This is where we begin the configuring.įirst, right click on 'Domains' on the left hand side, and select 'Add'. This is the welcome screen inside hMailServer. Here you enter the password you chose earlier in the installation. Check the 'Automatically connect on start-up' checkbox, and then click 'Connect'. There were different IP's in them that looked public I didn't know what I was looking at so I fixed it by unchecking the tab for now.On this screen, it allows you to connect to hMailServer. So if you mean that the SMTP server address is my PC because the hmail server resides on my PC, I understand that and with that change, and a few tweaks to hmserver, it appears to be sending out (my diagnostic message is the same as the original one posted again, with my system using the IP address of my PC in the SMTP tab.) If you are referring to something else please let me know.Īnother weird thing - I hate to mention it because I don't understand it - but I went into monitor and checked the voice mail options under the call tab, changed their color, and immediately my monitor screen filled with sip rx and sip tx messages, all in red, flying by to fast to read, that were different from my normal sip rx/tx messages that my sip trunks generate. Then there is a tab in the hmserver that directs the messages to gmail.

The instructions say that the SMTP tab in the IPO should be populated with the domain/name created in the hmail server.

RE: Hmailserver and IPO Embedded Voice Mail I do have a working 0.0.0.0 route, because I use remote teleworker software.ĭoes anyone have any suggestions on a) what filters I can use in monitor to see what's going on, or b) what I need to change in my configuration? This is a huge deal because so many of our smaller clients use gmail or godaddy, and if I could come up with a generic solution it would be of great value to them. I read a thread that referenced putting the ip address in an IP route, but heck if I had an IP address I wouldn't need all this - I'd just put it in the SMTP tab. I have the 'server requires authentication' box checked, and the email and passwords duplicate what I created as the user in hmail. Port: 2525, which is in the hmailserver as an SMTP portĮmail from address: which is my gmail domain with ipo added in front of it, and matches the domain and user name I set up in the hmail server. Server address: 192.168.1.24, which is the IP address of the IPO The SMPT screen on the IPO looks like this: If the above test shows the relay is working (I think that's what it is saying.) the problem has to be with my IPO setup? When I leave a voice mail in the IPO, none of the logs on the hmail server register, and I see no activity in monitor. No problems were found in the IP range configuration. Relative message paths are stored in the database for all messages. Trying to resolve MX records for .com.ĮRROR: MX records for domain .com could not be resolvedĬonnecting to TCP/IP address in MX records for local domain domain .com.ĮRROR: MX records for local domain .com could not be resolved Received: 220 ESMTP e12sm35744923pgu.48 - gsmtp.ĮRROR: Backup directory has not been specified. Trying to connect to TCP/IP address 173.194.202.108 on port 587. IPv6 support is available in operating system. HMailServer version: hMailServer 5.6.6-B2383 When I run the diagnostics on hmail, this is the message I receive: I am using a gmail account, and have gone through all the steps as thoroughly as I can. I have been following Kyle's post to set up hmail server to attempt to set up voice mail to email for a client.

Hmailserver gmail relay